This study investigation on the mechanical properties of Sagbama rice granite was analyzed to determine the load that would cause ultimate flexural stress on the material when used in concrete construction .This is necessary to make decision on where it is suitable for use. This study requires the production of 12 concrete beams of… Continue Reading
TABLE OF CONTENT TITLE PAGE… Continue Reading
Plastic bio-sand filter is a prototype of a slow sand filter which purifies water using sand and gravels of specific sizes of (0.36mm, 2.36mm, 6.35mm), this filter has been designed and constructed to evaluate its performance using raw water from fishpond at faculty of Engineering, Ahmadu Bello University Zaria and to remove pathogenic organisms… Continue Reading
The purpose of this project work is to assess the strength of No-fines concrete pavement. No-Fines concrete is use in low traffic volume, pathways, sidewalk and parking lots. No-fines concrete is produced by using ordinary Portland cement, coarse aggregates, and water. In this study, Two (2) batches of no-fines concrete each with two… Continue Reading
This project was undertaken to determine the geotechnical properties of soils along Appleton/Zoo road. A total of nine (9) samples, both disturbed and undisturbed, were collected at chainages - 0+275, 0+325 and 0+525 respectively and each drilled to a depth of 1 m and at sampling depths of 0–0.3 m, 0.3–0.6 m and 0.6–1.0 m… Continue Reading
This research will focus on the environmental and health impact of solid waste management in Saki West Local Government. Efforts will be directed to visit some houses, shops, markets, and commercial areas etc. and dumpsite located within Saki west LGA. The study will be limited only to those who generate waste and dispose waste, either to public… Continue Reading
ABSTRACT This study investigated the effect of rainfall on the physical, chemical and bacteriological quality of some selected hand-dug well water consumed by students of Ekiti State University, Ado-Ekiti. To this effect, six (6) samples from three (3) hand-dug well used, labeled (Ab, Bb, Cb & Aa, Ba, Ca)… Continue Reading
The sole purpose of this project work is to determine the settlement characteristics of soil for the construction of building, a case study at FUTO Senate Building area and FUTO NDDC hostel area, other objectives are the classification of the soil, determination of the strength properties of these soils and also making of sundry… Continue Reading
Soil is the ultimate foundation material which supports the structure. The proper functioning of the structure will, therefore, depend on the engineering properties of the underlying soil. The objectives of this research are to investigate the engineering properties of soils found in the site by conduction different types of laboratory… Continue Reading
TABLE OF CONTENT TITLE PAGE… Continue Reading
Plastic bio-sand filter is a prototype of a slow sand filter which purifies water using sand and gravels of specific sizes of (0.36mm, 2.36mm, 6.35mm), this filter has been designed and constructed to evaluate its performance using raw water from fishpond at faculty of Engineering, Ahmadu Bello University Zaria and to remove pathogenic organisms… Continue Reading
The purpose of this project work is to assess the strength of No-fines concrete pavement. No-Fines concrete is use in low traffic volume, pathways, sidewalk and parking lots. No-fines concrete is produced by using ordinary Portland cement, coarse aggregates, and water. In this study, Two (2) batches of no-fines concrete each with two… Continue Reading
This project was undertaken to determine the geotechnical properties of soils along Appleton/Zoo road. A total of nine (9) samples, both disturbed and undisturbed, were collected at chainages - 0+275, 0+325 and 0+525 respectively and each drilled to a depth of 1 m and at sampling depths of 0–0.3 m, 0.3–0.6 m and 0.6–1.0 m… Continue Reading
The study aimed to assess the quality of drinking water in Olowotedo community of Ogun state, Nigeria. Five samples were taken from different sources (wells, borehole, tap and sachet water) were analyzed, Selection of water samples was carried out using proportionate allocation, equal allocation, simple random sampling and systematic… Continue Reading
Time has come for people to know the implications of engaging non-professional builders in building construction works. The stoppage of engaging non-professional builders would reduce or even stop the event such as shoddy works, use of inappropriate materials/personnel’s and abandonment of project, cost overrun, and inadequate… Continue Reading
ABSTRACT The microbial fuel cells (MFCs) was used to generate electricity from waste water and fresh water, Design MFCs using different types of materials for the electrodes on the generation of electrical power from two MFCs, operated identically with a waste activated sludge… Continue Reading
Building cracks are most common type of problem in any type of building. So, it is important to understand the cause and the measures to be taken for prevention. Though cracks in concrete cannot be prevented entirely but they can be controlled by using adequate material and technique of construction and considering design criteria. Due to some… Continue Reading
Soils for engineering use are often classified based on properties relative to foundation support or as they might perform under pavements and in earthworks. Geotechnical classification systems today are designed to make it easy to equate field observations to estimates of engineering properties. As moisture content of a clay-like soil increases,… Continue Reading
In countries where industrialization is on the rise there is a corresponding increase in waste production resulting from industries which eventually upsetsthe environment and community for which they provide. While most of these waste generated are hazardous and should be managed, others could be put to appropriate use either directly or… Continue Reading
This project presents the results of the investigation conducted on a lightweight foamed concrete using different reagents; Sodium Lauryl Sulphate (SLS) and Lithofoam, with a view to determining its potential as a construction material in Nigeria. The properties investigated on the foamed concrete having target density of 1800kg/m 3 were:… Continue Reading
CERTIFICATION i DECLARATION AND COPYRIGTH ii ABSTRACT iii Dedication iv ACKNOWLEDGEMENT v Table of Contents vi LIST OF TABLES ix CHAPTER ONE 1 1.1 Introduction 1 1.2 Motivation statement 3 1.3 Problem statement 5 1.4 Objective of the study 6 1.4.1 Specific objectives 6 1.4.2 Research question 7 1.5 Scope of the project: 7 1.6 Expected outcome of… Continue Reading
This project is a fabrication of a standard drawing writing desk using the cheapest, effective and most readily available materials. Method of maintenance and services were also taken into consideration. The functional aspect of the equipment was also given adequate consideration in the project work. Also take into consideration the… Continue Reading
INTRODUCTION Retaining walls are structures used in providing stability for earth or materials where conditions dis allow the materials from summing its nature al slope or stability There are many factors affecting or militating against the stability of retaining walls. These includes the level of water table behind the wall, size of the base of… Continue Reading
INTRODUCTION This work was obligated to present in one. The fundamental and practical information in the filed of the comparative analysis of the strength of concrete made from various aggregate which may be useful to people involve in civil and structural engineering and particularly, those that found pleasure in the design and related structure.… Continue Reading
effects of aggregates sizes on concrete strength… Continue Reading